A Question concerning the point of the needle answered

On 14 February 2010 09:32, wrote:
This refers to an article of mine in Micscape UK QV on a mounted needle.

Hi ............
Yes I knew it!!!!!!!!.............. I should have spent more time writing about the point.

that was the really the point of the aticle I suppose.!!!................
I have to write that at first I could not find a tube that was 1mm external so I used 1.5mm diam. and had to shape the point by rotating it when it just protruded from my mark one version . I used a combination of a fine triangular file and very fine sandpaper to make a blunt point of about 0.3mm diam. at the end but the very end was flat and burnished flat and then painted with Matt black.
The relatively. large forams like Elphidium I glued on the round end with water based Gum tragacanth so that any part of the periphery could be imaged. by rotation .====Then I decided that a flat platform was also a good stage for angular shots of apertures .so I filed one side flat to create a flat stage 2mm long which bit into the end of the cylinder to a width of 0.3mm. I had to buy a brass vernier measure .
When I found my 1mm external hollow brass tube in Holland the diameter of the insert was 0.3mm and that was the right size without treatment except when I wanted the inclined stage. All the measurements were based on my wanting to look at the Foraminifera tests. and in particular those of +_ 500um diam.

So briefly Gumming with Gum Tragacanth on the end of the 0.3mm insert rod is how I now do it.

Centralisation on the end so would be trial and error whilst under the microscope as the tests are drying off..


Its up to you folk to develop it. I can see that some with a large(ThicK) mechanical finger on thir stage (ie the Clip)may need another slide glued underneath but that is not a problem. Also for reflected light only then a layer of paint underneath might look neater and avoid little glares!.

Also Please read info on the supply of 1mm hollow tubes
NOTE for integration into the text or at the end.

A SUPPLY OF 1MM HOLLOW BRASS TUBES.
At first I could not find any tube less than 1.5mm in diameter in the
UK. I had to use thicker glass up to 1.5mm but it
was much more difficut to cut neatly.

Even on line scanning on US sites, I found nothing; they still seem to
be using imperial measure anyway. Then I began to look at the EU and
sure enough there was the 1mm I was looking for on a Dutch site for
hobbyists.

http://www.plasticmodelbouw.nl/contact


The internal hole was 0.3mm which was just right. A pack of several
tubes was less than £10 with postage and took only 3 days BD.
Best wishes Brian Darnton. Swanage UK